Deutsch English

Switching power supply unit 12V/0.5A with EU plug

Switching power supply unit 12V/0.5A with EU plug
Zoom image

12,00 EUR

20 % VAT incl. excl. Shipping costs

Shipping time: 2 Weeks

Product no.: _PWR_ADP_12/0.5_0
For further information, please visit the homepage of this product.

Switching power supply unit 12V/0.5A with EU plug

Switching power supply unit 12V / 0.5A. Wallplug adaptor type. Cable length 1,8m with bare wires or DC jack connector upon request.

  • Plug type: C (CEE 7/16 Europlug)

  • Wiki tip: Mains power around the world - This article includes a list of countries and territories, with the plugs, voltages and frequencies they use for providing electrical power to small appliances and some major appliances

This product is compatible with:

TQS4 I - RS485 Interior thermometer

TQS4 I - RS485 Interior thermometer

Digital thermometer in an indoor make - for in-building temperature measurement. Measuring range is  -55 to +125 °C. Thermometer communicates via RS485 line on Spinel or MODBUS RTU protocol. The TQS3 intelligent temperature sensor can be connected to other modules by a single bus, which can be up to 1200 m long.

New feature: The users can now switch between the Spinel and Modbus RTU communication protocols using ModbusConfigurator software.

59,04 EUR (20 % VAT incl. excl. Shipping costs)
TQS4 O - Outdoor RS485 Thermometer

TQS4 O - Outdoor RS485 Thermometer

Description

A digital thermometer for RS485; outdoor design with IP65 protection. It measures temperatures in the range from -55 ° C to +125 ° C and the measured value is sent in degrees Celsius. The thermometer has very low consumption and communicates via Spinel or MODBUS protocols. The TQS3 intelligent temperature sensor can be connected to other modules by a single bus, which can be up to 1200 m long.

New feature: The users can now switch between the Spinel and Modbus RTU communication protocols using ModbusConfigurator software.

59,04 EUR (20 % VAT incl. excl. Shipping costs)
GNOME485 - Ethernet to RS485 converter

GNOME485 - Ethernet to RS485 converter

Inexpensive Ethernet - RS485 converter. Enables a device with RS485 to easily connect to the Ethernet or to extend the RS485 line via the Ethernet. Power supply 5 to 30V. Virtual COM port. Protocols: TCP/IP, UDP.

150,24 EUR (20 % VAT incl. excl. Shipping costs)
AD4ETH - Ethernet measurement module

AD4ETH - Ethernet measurement module

Analog measurement module AD4ETH is a four input A/D converter allowing you to measure up to four analogue signals 0-10V or 0(4)-20mA. Measured-out values can be viewed via a WEB interface, AD4ETH also supports TCP, SNMP and many other protocols.

from 284,40 EUR (20 % VAT incl. excl. Shipping costs)
QuidoDuplex ETH 4 - Extender of digital I/Os, Ethernet

QuidoDuplex ETH 4 - Extender of digital I/Os, Ethernet

QuidoDuplex ETH is a set of two I/O modules for Ethernet (LAN, computer network) with a special firmware designed specificaly to transmit digital I/Os over Ethernet as an autonomous system - no PCs or PLCs needed. If one input is turned on, the corresponding output on the other unit is also turned on. Bi-directional.

Variants: Digital inputs / outputs: 4 in both ways or 8 in both ways

from 369,60 EUR (20 % VAT incl. excl. Shipping costs)
QuidoDuplex RS - Extender of digital I/Os, RS485

QuidoDuplex RS - Extender of digital I/Os, RS485

QuidoDuplex RS is a set of two I/O modules for RS485 line (two wires only) with a special firmware designed specificaly to transmit digital I/Os over RS485 line as an autonomous system - no PCs or PLCs needed. If one input is turned on, the corresponding output on the other unit is also turned on. Bi-directional.

Varianten: Digital inputs / outputs: 4 or 8 in both ways

from 206,88 EUR (20 % VAT incl. excl. Shipping costs)

Customers who bought this product also bought the following products:

TME - Ethernet Thermometer with Sensor

TME - Ethernet Thermometer with Sensor

TME is a Thermometer with direct output to Ethernet (IP Thermometer), Measuring range is -55°C to +125°C.

TME has an internal WEB server, which allows you to view Temperature directly in your WEB browser - no additional software is required. TME is fully configurable via WEB interface, Temperature can be transmitted over TCP/IP in ASCII (no conversion needed). Supported protocols are: TCP, SNMP, SMTP (e-mail), MODBUS TCP a XML. Temperatue can be easily integrated in your existing WEB site vias standard HTTP GET functions.

Sensor cable is 3 meters long as a standard. If you require, we can produce TME with up to 20m sensor lead. Do not hesitate to contact us if you need a different length.

from 169,56 EUR (20 % VAT incl. excl. Shipping costs)

This Product was added to our catalogue on Wednesday 26 March, 2014.

[<<First] | [<Back] | [Overview] | [Next>] | [last>>] | Product 5 of 8 in this category

Shopping cart

You do not have any products in your shopping cart yet.

Welcome back!

E-mail address:
Password:
Forgot your password?

Newsletter subscription

E-mail address:

Customer group


Customer group: Guest

Manufacturer information

Papouch
More products

Manufacturer

Parse Time: 0.262s